Make a helmet hat base but have the bubble on the tip end about 3 inches. This is the dolphin’s nose.

Pinch off a 1 inch bubble on the arch near the dolphin’s nose.

Make a pinch twist out of the 1 inch bubble and center it under the nose.

At the back of the hat base wrap your hand around all three bubbles and make them into about 5 inch bubbles.

Carefully twist the three 5 inch bubbles.

Inflate a 160 leaving about a 3 inch tip and attach it to the front of the dolphin.

Make a bubble with the 160 the same length as the body of the dolphin.

To make its side fins make an 8 inch bubble followed by two 3 inch bubbles and finish with another 8 inch bubble.

Twist the bubbles to form fins.

Add two pinch twists on the top of the dolphin, and between the two side fins.

Make a dorsal fin between the 2 pinch twists.

Add a pinch twist under the dolphin on his belly. Make a bubble the same size with the left over 160.

Fully inflate a 260 and burp to soften (very soft). Make two equal bubbles.

Make 2 bubbles about 6 inches or so.

Twist the bubbles to form loops. It should look like a bow.

Spiral the two bubbles and twist off two 1 inch bubbles at the ends.

Twist the spiral in at the base of the dolphin’s body. Pinch twist the bubbles with knots on them. Place one underneath the dolphin’s belly.

Fully inflate two 260s and spiral them together leaving 9 inches or so on the ends. Make two 1 inch bubbles and twist together.

Pinch the 2 bubbles to form loops.

Insert the flippers of the dolphin into the loops.